Injection Transformer

HV Injection Transformer

Our range of injection transformers allow a grounded signal generator to apply a disturbance signal to non-grounded circuits. The range includes models with frequencies from DC to 35MHz and they are primarily used in loop responce analysis.

Further Details (PDF, 66Kb)

LCR Active Head

LCR Active Head

The LCR Active head incorporates the automatically selected 0.1% shunts combined with input buffers and Kelvin connection circuits to provide a simple and accurate alternative to passive impedance measurement with PSM17xx series frequency response analyzers.

Further Details (PDF, 98Kb)

Impedance Analysis Interface

Impedance Analysis Interface

With a high frequency circuit design, internal amplifier for increased current in low impedance applications and compensation with the associated PSM17xx unit, the IAI provides higher accuracy impedance analysis over a wider frequency range.

Transimpedance Amplifier

TA107

For applications requiring the measurement of impedance above the range of either the LCR Active Head or IAI, the TA107 uses an innovative virtual earth transimpedance techique to offer an impance range up to 100G Ohm.

Further Details (PDF, 131Kb)

PSM1735 Single Ended Adaptor

Single ended BNC adaptor

The single ended adaptor converts the two ground referenced differential inputs of a PSM1735 input channel to single floating BNC input.

Power Adapter

PSM Power Adaptor

Using torroidal transformers and calibrated burden resistors, the Power Meter Adaptor provides isolation and fixed scaling factors that enable the PSM units to make input power measurements on electronic products that connect to a single phase low voltage AC supply.
Further Details (PDF, 98Kb)

Telecom Test Fixture

TTF35

Used in conjunction with the PSM1735 Phase Sensitive Multimeter, the TTF35 provides a simple, fast and accurate measurement solution to ADSL and VDSL telecom filter attenuation testing.
Further Details (PDF, 197Kb)

2.5kv HV Probe

2.5kV HV Probe

With a x100 attenutation ratio, wide frequency range and 2,500V dc or ac peak rating, the TT-HV 250 probe allows the PSM series frequency response analyzers to be used in high voltage ground referenced measurement applications.
Further Details (PDF, 66Kb)

15kv HV Probe

15kV HV Probe

With a x1000 attenutation ratio, wide frequency range and 15,000V dc or ac peak rating, the TT-HVP 15HF probe allows the PSM series frequency response analyzers to be used in high voltage ground referenced measurement applications.
Further details (PDF, 131Kb)

HF Series Shunt

HF Shunts

Passive impedance analysis with a series connected resistive shunt is usually limited due to the relatively high parasitic reactance of the shunt. This problem is massively reduced by a unique field cancelation technique incorporated in the HFm series shunts.
Further Details (PDF, 98Kb)

IAI Kelvin Fixture

IAI Kelvin Fixture

The IAI Kelvin fixture enables the user to place components between the spring loaded plates, this enables repeatable readings without the uncertainty accosiated when probing components with loose cabling. Proving accurate results to high frequencies.