Injection transformer range
N4L accessories
When testing the transfer function of a control loop, a 'disturbance signal' from which frequency response analysis can be made is 'injected' into the loop.
In order to ensure that the test system does not change the transfer function results, it is important that the signal generator providing the disturbance signal is isolated from the circuit being tested.
This isolation can be achieved using a transformer that meets the frequency range and voltage isolation requirements of a specific test environment, so N4L offer a number of different injection transformer models.
Models and specifications
Standard injection transformer
- Frequency range: 10Hz to 200kHz with flatness +0dB -3dB
- Turns ratio: 6.3 : 1
- Size: 31x92x38mm
- Voltage rating: 50V
HF injection transformer
- Frequency range: 500Hz to 35MHz with flatness +0dB -3dB
- Turns ratio: 2.3 : 1
- Size: 31x92x38mm
- Voltage rating: 50V
HV injection transformer
- Frequency range: 5Hz to 15MHz with flatness +0dB -3dB
- Turns ratio: 2.3 : 1
- Size: 31x111x60mm
- Voltage rating: 600V Cat II
Low Frequency Injection Module (LFIM)
- Frequency range: DC to 100kHz with flatness +0dB -3dB
- Input power: 12V (Universal power adaptor supplied standard)
- Opto isolated active circuit
- Turns ratio: 3.1 : 1
- Size: 44x110x82mm
- Voltage rating: 600V Cat II
» Contact our sales department to discuss your requirements...
This product is designed, manufactured & supported in the UK. All measurements are traceable to UKAS, certificates of conformance and calibration are supplied as standard. Our products are CE marked.
PSM1700 testing an SMPS with a standard injection transformer
Injection Transformer
Downloads
Brochure & Technical Specifications PDF, 33Kb